Futaba 7C 2.4GHZ Heli Tx/Rx Only

Instruction Manual (2.5 MB)

•  This is the Futaba 7C 2.4GHz Helicopter Radio System with the R617FS FASST 7-Channel Receiver and no servos.             

•   This is the helicopter version which will default to heli settings when powered up and does not have a ratcheted throttle stick.       

•    Modeler can change from the default mode (mode 2 in USA) by holding the Mode and End keys and then turning transmitter On to access the STK feature,changing mode and turning transmitter Off and then On again.           

•    It is recommended to send transmitter to the Futaba Service Center  to change switch operation.  

FEATURES:

• Futaba's FASST (Futaba Advanced Spread Spectrum Technology) shifts every two milliseconds virtually eliminating signal conficts andinterruptions unlike other 2.4GHz systems that only stay on one or two frequencies

• Dual antenna diversity enables FASST system to automatically and seamlessly select the best reception between the two antennas built into the receiver ensuring that the aircraft stays under constant control of transmitter regardless of altitude

• Newly designed Dial-N-Key jog dial with joy stick button allows cursor movement in four directions for very user friendly navigating through menus and programming

INCLUDES:

• Futaba 7C 2.4GHz Transmitter

• R617FS FASST 7-Ch Receiver (FUTL7627)

• FBC-19B(4) 120V Battery Charger (FUTM1830)

• NT8S600B 600mAh 9.6V NiCd Transmitter Battery (FUTM1457)

• Switch Harness w/Charge Cord (FUTM4370)

• Black Transmitter Neck Strap (FUTM5690)

• Servo mounting hardware and instruction manual

SPECS:

7C 2.4GHz Transmitter
Current Drain: 170mA

R617FS FASST Receiver
Size: 1.6 x 1.1 x .35" (40 x 27 x 9mm)
Power Requirement: 4.8 - 6V
Current Drain: 80mA (at no signal)
Weight: 0.34oz (9.8g) with case, 0.25oz (7g) without case